How to force Zafira B DPF Regeneration with OPCOM


Opcom OP-Com 2010 V Can OBD2 Pour Opel Firmware V1.45

I have an opcom 2010 with v145 firmware and have successfully done a DPF regen on my Zafira B the other day. Below is an instruction on what I did.

Warning
The exhaust gas temperature will increase to over 600°C, so you must perform this outside, on a non-flammable ground. The regeneration procedure is completely controlled by the engine control unit.

Prerequisites
Engine is running at idle
Engine is fully warmed up

Disclaimer
This regeneration, if carried out is of responsibility of those carrying it out.
EDC16 System

Process
Connect OP COM opcom interface to the car and the laptop that contains opcom software.
Open up the software.
Go through the system as GM based Saab > and then selected Zafira B with DPF when prompted.
Go to “Particulate Filter Regeneration".
Click “Start Regeneration”.
 op-com-2010-v-1
Note
To avoid consequential damages, the DPF regeneration must be executed only once!
After "DPF Regeneration" is finished live data "Diesel Particulate FilterSaturation" will show 70%.
When engine controller has performed a dynamicregeneration value will be changed.

DECE01 System
op-com-2010-v-2
This modification can also work on the following models:
Astra-H
Z19DT, Z19DTH, Z19DTL, Z17DTR, Z17DTJ
Zafira B
Z19DT, Z19DTH, Z19DTL, Z17DTR, Z17DTJ
Vectra-C / Signum
Z19DT, Z19DTH, Z19DTL
Corsa-D
Z13DTH, Z17DTR
Antara
2.0LDiesel engine