How to Setup and Update V4.94 Digiprog 3


Recently, newly launched V4.94 for Digiprog 3 master programmer has aroused keen interest from many users. Under this case, two related questions put forward by a majority of users are listed below:

1.How to update Digiprog 3 to the newest V4.94

Except you directly buy a newest V4.94 digiprog 3, or else you need to update for your old version one. Whether V4.88 or 4.85, you can smoothly update via Newest Digiprog 3 V4.94 Update Software.

2.How to setup V4.94 Digiprog 3 (or Digiprog 3 setup instruction)

1). Connect Digiprog 3 main unit into the ODB diagnostic socket (Notice: Do Not use cigar lighter lead, or else it will lose the warranty)
2). The Digiprog 3 main unit power on when finish STEP 1, and it turns to load the system.
3). A while later, the screen will display Digiprog 3 software version information, software is marked as a unique 12 digit electronic serial number.
4). Then the screen will appear with a disclaimer regarding the use of machine.
5). Click “Check/Tick” to start using the digiprog 3 odometer master programmer.
v494-digiprog-iii-1
6). It needs to input password to enter into the system. The default password is “1”.
v494-digiprog-iii-2
7). Welcome the main interface. You are also allowed to check the software version marked red on the following picture.
v494-digiprog-iii-3
8). Select the function you need to do and follow the screen instruction.